Van's Air Force

The definitive Van's Aircraft support community! Buying, building or flying an RV? Join our exclusive family of mentors and enthusiasts!

Latest activity

  • A
    ALS12 reacted to GaryK's post in the thread Fuel Tank Testing with Like Like.
    I did the balloon thing with soapy water. Tested the ability to see bubbles by loosing one of the AN caps slightly, the bubbles showed...
  • L
    lr172 replied to the thread Idle mixture/rpm.
    Sorry, that instruction was specific to servos. A good starting point on a carb is to run the needle (what is at the other end of that...
  • T
    Might try some MEK and see if that takes it off. Wear gloves...
  • B
    bdavis79 replied to the thread Max RPM Ground Runup Question.
    I had a similar issue occur. As I advanced the rpm past 1900, it would stumble terribly like it was too rich and smooth out once leaned...
  • L
    And vans also says to radically reduce gross weight when extended range tanks are used, so there is that political component. I don’t...
  • K
    Here is a link to one from a post in another forum. Size approx 6 1/8" x 5 1/8"
  • donmtt
    donmtt replied to the thread LOP dilemma.
    The biggest issue I have seen over the years is not pilots RUNNING LOP, it's pilots GETTING to LOP. You must not meander in the "red...
  • E
    eison replied to the thread Fuel Pressure issue.
    I will do a better ground run test tomorrow at a higher power setting to see how it acts on the ground under a higher load.
  • P
    phloidtrout replied to the thread FS: Panel Upgrade Parts.
    Dropped you a DM regarding the G-Meter.
  • E
    eison replied to the thread Fuel Pressure issue.
    It is a new install and a new problem. All new components. I did verify that the replacement and the original Mechanical pump were...
  • L
    I will post a copy for you tomorrow. The heavy hartzell is a help here. I am pretty stock and use 2 pc680 type batteries. My O2...
  • Walt
    Walt replied to the thread Fuel Pressure issue.
    The mechanical pump traps the fuel pressure going forward, the inlet will have no trapped pressure. Is this a new install or a new problem?
  • M
    I’m very sorry for your loss. Thank you for taking the time to write this.
  • Walt
    Walt replied to the thread Alt Static Air Source Options.
    I like simple so I just dropped a short section of nylo tube down where the vent is and cap it off with some nylo fittings that are easy...
  • D
    drinkwater reacted to airguy's post in the thread LOP dilemma with Haha Haha.
    Well, their "good reputation" just took a powerdump here on this forum. Might be best if you didn't name them at this point.
Back
Top