snoopyflys
Well Known Member
Hi All,
I will be removing the main gear from my -7A for re-powder coating. I will be using a couple of wing jacks on the tie downs to lift the plane. Does anyone have suggestions for supporting the plane while on the wing jacks? Thinking about using a couple of padded saw horse positioned under the fuse center section to help support the plane and not solely depend on the wing jacks. Is this location an acceptable location if the wings and engine are installed? Do I need to support the tail as well?
Thanks as always
I will be removing the main gear from my -7A for re-powder coating. I will be using a couple of wing jacks on the tie downs to lift the plane. Does anyone have suggestions for supporting the plane while on the wing jacks? Thinking about using a couple of padded saw horse positioned under the fuse center section to help support the plane and not solely depend on the wing jacks. Is this location an acceptable location if the wings and engine are installed? Do I need to support the tail as well?
Thanks as always