I installed a rebuilt MA-4SPA carb on my RV-6. The only thing I’m not 100% certain on is the torque setting on the fuel line connection. Picture below.
I tightened to 40 inch/pounds per a note I read previously. No sealant or picture of any kind. Is that all I have to do? I do not have any leaks and have test run.
Just not sure if there is any type of safety required in the connection. The nut size was 11/16” and I believe that equates to a # 6 B nut.
I tightened to 40 inch/pounds per a note I read previously. No sealant or picture of any kind. Is that all I have to do? I do not have any leaks and have test run.
Just not sure if there is any type of safety required in the connection. The nut size was 11/16” and I believe that equates to a # 6 B nut.