Builders
I’m nearly complete with riveting the emp skins. The next step on page 10-20 step 6 is riveting the F1079 bottom skin, no sweat…
Well, it doesn’t fit I went to cleco it in place and when I wrap it aroundthe skins it’s a 1/16 off from the rivet holes on the opposite skin side. No amount of squeezing the tail is going to get the holes lines up.
When I clecoed everything together and match drilled it was extremely tight but manageable.
I leveled it out and it’s leveled, so no twist.
Maybe it’s the primer on all the parts…
Wondering if I can order a new skin with no holes on one side so I could match drill it.
Anyone encounter this problem and if so how did you handle it.
Thanks
I’m nearly complete with riveting the emp skins. The next step on page 10-20 step 6 is riveting the F1079 bottom skin, no sweat…
Well, it doesn’t fit I went to cleco it in place and when I wrap it aroundthe skins it’s a 1/16 off from the rivet holes on the opposite skin side. No amount of squeezing the tail is going to get the holes lines up.
When I clecoed everything together and match drilled it was extremely tight but manageable.
I leveled it out and it’s leveled, so no twist.
Maybe it’s the primer on all the parts…
Wondering if I can order a new skin with no holes on one side so I could match drill it.
Anyone encounter this problem and if so how did you handle it.
Thanks