Pheonix137
Member
Hi Gents,
When I ordered my finishing kit for my 7, I initially was going to use an 0-360. subsequent to this, I landed a good IO-360 angle valve engine.
Now I would like to know how well this fits into the -7 0-360 vertical induction cowl (old RV6 cowl) I suspect it will be tight, but using this cowl with some minor mods to the induction area, could save me the $1400 for a new cowl.
Would anyone perhaps have pics of this setup?
Regards
Dennis
When I ordered my finishing kit for my 7, I initially was going to use an 0-360. subsequent to this, I landed a good IO-360 angle valve engine.
Now I would like to know how well this fits into the -7 0-360 vertical induction cowl (old RV6 cowl) I suspect it will be tight, but using this cowl with some minor mods to the induction area, could save me the $1400 for a new cowl.
Would anyone perhaps have pics of this setup?
Regards
Dennis