Hi.
I'm installing dual P-mags on my Superior IO-360.
I'm also installing Vans DC load center EXP-2V and the ACS A-510-2 ignition switch (key-switch)
The P-mag wiring diagram says to connect pin 5 (+13,8 v dc) to the main bus via a switch and breaker.
I've installed two separate switches/breakers for this purpose, but here's the question:
Since I don't have a separate main bus, where schould I connect the wire from pin 5?
(I assume wire 5 is the primary power source for the P-mags?)
So far, my thoughts are to connect pin 5 to a pin on the EXP-2 panel which is always powered, for example the "clearance delivery pin".
Or maybe I schould wire pin 5 to the shunt or the battery? That way, the P-mags will be completely independent of the EXP-2 panel. And they are protected via the separate switches/breakers.
Second question:
Is it correct that the wires from the key switch to the magnetoes are the two shown on the P-mag diagram? (P-lead = "kill switch)
Or am I completely confused here??
In short: how schould I wire up the P-mags with Vans EXP-2 panel and the ACS igntion key switch?
I'm installing dual P-mags on my Superior IO-360.
I'm also installing Vans DC load center EXP-2V and the ACS A-510-2 ignition switch (key-switch)
The P-mag wiring diagram says to connect pin 5 (+13,8 v dc) to the main bus via a switch and breaker.
I've installed two separate switches/breakers for this purpose, but here's the question:
Since I don't have a separate main bus, where schould I connect the wire from pin 5?
(I assume wire 5 is the primary power source for the P-mags?)
So far, my thoughts are to connect pin 5 to a pin on the EXP-2 panel which is always powered, for example the "clearance delivery pin".
Or maybe I schould wire pin 5 to the shunt or the battery? That way, the P-mags will be completely independent of the EXP-2 panel. And they are protected via the separate switches/breakers.
Second question:
Is it correct that the wires from the key switch to the magnetoes are the two shown on the P-mag diagram? (P-lead = "kill switch)
Or am I completely confused here??
In short: how schould I wire up the P-mags with Vans EXP-2 panel and the ACS igntion key switch?
Last edited: