So I have installed my MT prop governor on the back accessory pad of my AeroSport Power IO-375 engine. I have fingered tightened the nuts on the mounting studs but now I need to torque these nuts. Anyone have any ideas about torquing these nuts? I cannot get a socket or a crows foot on the nuts. I can get an open end wrench on the nuts but that’s it. Do I need to get a special socket or make a special tool to accomplish this task? Thanks for any suggestions.
John Van Lieshout
RV6A 85%
C-FMYM (reserved)
AeroSport Power IO-375M1S 195hp
VPX Pro &PPS
Garmin G3X Touch 2 screen suite
John Van Lieshout
RV6A 85%
C-FMYM (reserved)
AeroSport Power IO-375M1S 195hp
VPX Pro &PPS
Garmin G3X Touch 2 screen suite