Hi All
Adding an IFD540 to my panel soon and looking for tips on cutting the hold in the secondary bulkhead behind the panel (RV-7A Slider) for the long tray.
Why re-invent the wheel with all the smart folks on here... right?
I plan on four holes in the corners, but then a saw? Nibbler? Anything better?
Thought about clamping a piece of wood in there to dampen vibrations if I go the saw route.
Thanks in advance-
dan
Adding an IFD540 to my panel soon and looking for tips on cutting the hold in the secondary bulkhead behind the panel (RV-7A Slider) for the long tray.
Why re-invent the wheel with all the smart folks on here... right?
I plan on four holes in the corners, but then a saw? Nibbler? Anything better?
Thought about clamping a piece of wood in there to dampen vibrations if I go the saw route.
Thanks in advance-
dan