43.13 Roll Servo D-sub

[Hashtag#]

Can someone point me to 43.13 or an ASTM that provides instructions on securing or mounting this d-sub for a roll servo? 43.13 Section 11-235 seems to apply to certificated aircraft with d-sub flange mounts and 11-147 is for wire bundles. Any insight is appreciated.

 

[hgerhardt]

You're missing the hardware for the backshell (long screws). Can order via Amazon etc.

 

[Hashtag#]

Thanks for the info on the long screws. Is the backshell clamped or zip tied to the rib?

 

[RV7 To Go]

I zip tied the connector between the rib lightening holes. Never moved in over 800 hours of flying. Different connector but works for Dsub as well.

 

[Mel]

I zip tied the connector between the rib lightening holes. Never moved in over 800 hours of flying. Different connector but works for Dsub as well.

View attachment 121510

Not to be nosey but I think I see a locknut with no threads showing through.

 

[RV7 To Go]

Not to be nosey but I think I see a locknut with no threads showing through.

That was an early pic before first flight. The bolt was changed. Good eye!