sloengineer
Active Member
I wanted to share a few improvised tools I used for rib shaping. I wanted a nice round where I had to grind the VS ribs to fit the skin. I used the side of a #40 drill bit to make a stress relieving round. Then used a little 240 grit 3M wet or dry sandpaper wrapped around a hacksaw blade to get in those hard to reach areas.
I’m sure I’m not the first to think of this, but I didn’t see it anywhere else on here.
Cheers!
I’m sure I’m not the first to think of this, but I didn’t see it anywhere else on here.
Cheers!