I'm currently flying in Phase 1, and I have seen that the trim is very sensitive at higher airspeeds. I have a VPX, and have activated the speed trim function, and set it for 70% at 120 its or above. It works as advertised ON THE GROUND in simulated airspeed mode.
In the air, however, the trim ceases to function at 120 or above. The indicator shows it is getting a command but the trim doesn't move. I then increased it to 85% and it works but it is still very sensitive.
My question to the group is if anyone has experienced this issue or is it possible that I have a faulty RAC servo? It apparently does not have the necessary power to drive the trim at a reduced voltage in my case...
Thoughts?
In the air, however, the trim ceases to function at 120 or above. The indicator shows it is getting a command but the trim doesn't move. I then increased it to 85% and it works but it is still very sensitive.
My question to the group is if anyone has experienced this issue or is it possible that I have a faulty RAC servo? It apparently does not have the necessary power to drive the trim at a reduced voltage in my case...
Thoughts?