just recently ordered an RV-14 empennage kit and am trying to come up with ways to make this an easier build than previous kits (none of which have I finished). One of my biggest problems previously was riveting. If I can pop it, squeeze it or back rivet it then it comes out quite well. But, if it has to be pounded, in can be an issue. My question to you is do you have any recommendations for any tools that may be helpful in the process. I see some folks using swivel mushroom sets, sets with rubber skirts, long sets that look like foot long rods, etc. What I have used in the past is a small tungsten bucking bar as well some other various shaped steel bars. Although I have had decent success with these the main issue is consistency. I’d love to hear any techniques, videos, tools, etc. that might help. As always, thanks so much for your time and input….