BH1166
Well Known Member
Need to reduce the voltage of 4.8v by using, per GRand Rapids documentation, a 200 ohm resistor. They call this a red black black black band resistor. Since my fuel pressure is wonky, thought I’d look to see what I have installed ( did not build) . Pictured is what is installed….not red black black black. Anyone electronically knowledgeable to say what I have installed? Looking on line on how to read is confusing, and doesn’t fit anything. Also, do you happen to know what 4.8v will be reduced to by use of my installed resistor?
Blue is 4.8 voltage pin/line, Gray/black is the wire going to VDO fuel pressure sender ( carb engine) .
Yes, I see what appears to be a burned, scraped, damaged gray/black wire, but not cut, appears to be solid.
Thanks
Blue is 4.8 voltage pin/line, Gray/black is the wire going to VDO fuel pressure sender ( carb engine) .
Yes, I see what appears to be a burned, scraped, damaged gray/black wire, but not cut, appears to be solid.
Thanks