Landing gear mount rivet interference.

I’m in the process of putting the landing gear mount in on my 7A. The bottom rivet on the side skin doubler plate is interfering with the mount so it won’t fit tight against the side skin. Anyone had this problem? I think the only remedy is to grind a little off the mount where it’s touching the rivet. I don’t see any other options.

I've got the taildragger instead of the nose dragger, so I don't even have this component. But I see what you're talking about. Is everything else sitting flat--has the hole in the bottom skin been cut out as shown so the weldment isn't sitting up proud of the bottom skin? If all that is positioned as it should be, it would seem the only option is to notch the weldment to get some clearance on that one rivet hole. Make sure it's not going to infringe on the edge distance for that first bolt hole, though. Hopefully, an "A" builder will chime in that's already had to deal with this issue. If not, I'd call Van's to make sure.

Yep, I had the same issue. I just ground a little off the mount.