In the area around F-710 bulkhead, the F-779 skin overlaps the F-773 skins (F-779 inside of F-773). There is no way to make the F-786C J-channel flush with the skins in this area (particularly about 1 rivet forward) as it bends inward. Am I missing something?
Others have said that the J-channel does not get sandwiched between the 2 skins, but that is the only way I can see that it would be flush with the side skin. But the the bulkhead would not be flush in the j-channel cutout.
Thanks in advance!
Others have said that the J-channel does not get sandwiched between the 2 skins, but that is the only way I can see that it would be flush with the side skin. But the the bulkhead would not be flush in the j-channel cutout.
Thanks in advance!
Last edited: