A6intruder
I'm New Here
I've been doing a lot of small parts in a 3 quart batch of Alodine over the last two weeks. Last night I realized my parts didn't seem like they were taking on much color, even when I upped the time from 3 minutes to 8 minutes. I think I may have let too much light get to the Alodine solution and it has become ineffective.
Can I just re-etch those parts and then use a new Alodine solution to get a proper Alodine surface treatment?
I would test on an unimportant part (easily replaced).
Thoughts?
Dan
Can I just re-etch those parts and then use a new Alodine solution to get a proper Alodine surface treatment?
I would test on an unimportant part (easily replaced).
Thoughts?
Dan