I saw this on a rocket. After reading threads for an hour, i was thinking of how it’s done.
I like the idea of a fairing that could be removed and reused in the event the windscreen needed replacing.
Here is how I think it would be done.
Fit and drill windscreen for screws. No rivets.
Proseal (I have a fresh can on hand) using screws to hold in place.
Remove screws and glass the frame.
Pop the frame off, trim and sand. And fill those micro pores of course.
Apply a thin bead of proseal around the perimeter of the fairing frame and screw in place.
Any guidance would be appreciated.
I like the idea of a fairing that could be removed and reused in the event the windscreen needed replacing.
Here is how I think it would be done.
Fit and drill windscreen for screws. No rivets.
Proseal (I have a fresh can on hand) using screws to hold in place.
Remove screws and glass the frame.
Pop the frame off, trim and sand. And fill those micro pores of course.
Apply a thin bead of proseal around the perimeter of the fairing frame and screw in place.
Any guidance would be appreciated.
Attachments
Last edited: