I have a G3Xt, GTN650 and GMC507.
When selecting a holding at a way-point in the GTN650 flightplan, it comes up nicely on the G3Xt and the autopilot flies it ok. (external navigator select).
However if I push "edit holding" and make a change within the holding ie, 90 deg instead of 270 deg or left hand to right hand holding, pushing "load hold" button and confirm OK, the autopilot flies it correctly, but the change is not showing on the G3Xt screen. (the non corrected holding shows).
In preview the change is shown correctly on the GTN650.
If I close the map view on the G3Xt and reopen the map the changed holding
shows up correctly.
When doing the same operation in the Garmin trainer, the changed holding
shows in the PFD as soon as I push the button "load hold" + OK.
I have the latest updates on the G3Xt and GTN650. (not Xi).
This would be something for the G3X experts.
Thanks.
When selecting a holding at a way-point in the GTN650 flightplan, it comes up nicely on the G3Xt and the autopilot flies it ok. (external navigator select).
However if I push "edit holding" and make a change within the holding ie, 90 deg instead of 270 deg or left hand to right hand holding, pushing "load hold" button and confirm OK, the autopilot flies it correctly, but the change is not showing on the G3Xt screen. (the non corrected holding shows).
In preview the change is shown correctly on the GTN650.
If I close the map view on the G3Xt and reopen the map the changed holding
shows up correctly.
When doing the same operation in the Garmin trainer, the changed holding
shows in the PFD as soon as I push the button "load hold" + OK.
I have the latest updates on the G3Xt and GTN650. (not Xi).
This would be something for the G3X experts.
Thanks.