I'm looking at the plans, or rather I was looking at the plans as they are out in the hangar so I cannot reference the page. When the two skins are to be attached together the plans state to only install one LP4 (I think that is the rivet called out, I need two sets of plans) in the forward most hole. I'm wandering if anyone knows why two holes are present if only one is used?
I'm only at the step of back riveting the skins to the stiffeners and looking ahead so I could be mistaken on the use of only one rivet .
Thanks Ron
I'm only at the step of back riveting the skins to the stiffeners and looking ahead so I could be mistaken on the use of only one rivet .
Thanks Ron