Replacing my VM1000 w/ the EDM 350. Running across some strange problems. Unfortunately, JPI is non-responsive to emails and a call to ‘tech support’ resulted in 30min on hold before I gave up.
- EDM doesn’t recognize my resistive senders. It’s configured for resistive. Multimeter showes 79 and 58ohms for L & R tanks at the correct pins on the EDM.
-EDM doesn’t see the MAP sensor even though it’s their brand new sensor & harness.
- I read something else that the Tach won’t recognize until I run the engine? So far, no Tach recognized as well.
Thanks for any tips,
Brian
- EDM doesn’t recognize my resistive senders. It’s configured for resistive. Multimeter showes 79 and 58ohms for L & R tanks at the correct pins on the EDM.
-EDM doesn’t see the MAP sensor even though it’s their brand new sensor & harness.
- I read something else that the Tach won’t recognize until I run the engine? So far, no Tach recognized as well.
Thanks for any tips,
Brian