Would like to hear how others have dealt with the situation with the pin installation for the two hinges on either side of the cowl. There must be some way to facilitate access to the hinge for installing the pin. Does not seem possible with rivets on the most forward 6" of the hinge. All that I can come up with is to replace those first 6 (pairs of) rivets with nutplates. With the screws out, the hinge can be bent out that 3" to come into view through the cowl inlet.
Thanks.
Cliff Dominey
RV8A N977CD (registered!)
Thanks.
Cliff Dominey
RV8A N977CD (registered!)