View Single Post
  #9  
Old 11-26-2021, 12:47 PM
BobTurner BobTurner is offline
 
Join Date: Dec 2011
Location: Livermore, CA
Posts: 8,157
Default

Quote:
Originally Posted by osaleh View Post
Thank you Dave. I am using the slick magnito model 4373. No electronic ignition. I think i am clear on the diagram but do not understand the jumper wire. So i install a jumper wire from right terminal to GND terminal? This configuration is for one Non Impulse coupled magneto and one electronic ignition. I am not sure i have this configuration. so question is , do i just follow the diagram as is as far as installing the jumper?
The diagram shows the connections when using an impulse mag on the left, and a non-impulse mag on the right. The jumper disables the right mag on starting. If you are using two impulse mags (as it appears you are) then you want both enabled for start - no jumpers.
Reply With Quote