J

JDA_BTR

Well Known Member
On page 14-03 it says to make the W-1025A flap hinge brackets flat. Two of mine were very nearly flat on arrival so a little adjustment and I'm satisfied. The third and fourth ones have complex bends in them. One I got very nearly flat and am satisfied. The fourth one though I can't get it there - it won't lay table flat.

But - it is within 1/32" end to end. Is that flat enough? I asked Vans yesterday but haven't heard yet. I've spent a lot of time on it getting it that good. If it isn't good enough I'm thinking of ordering another and trying to hope I get a better one next time.
 
Not flat enough

Thought mine were flat until I put the bearings in. 3 of the 4 were binding. One I flattened them out they worked ok
 
caapt said:
Not flat enough

Thought mine were flat until I put the bearings in. 3 of the 4 were binding. One I flattened them out they worked ok
Click to expand...
Caapt, how did you go about flattening them once they were mounted? Or did you notice the binding before they were permanently installed?
 
You must log in or register to reply here.