Well I do at times........ Winter to summer mogas changeover season has always been a challenge - the winter mogas on a warm day would lead to some issues, like fuel boiling in the fuel line, and carb, leading to an over rich condition on take off with a corresponding stumble after a hot...

I have had my RV-12 for about two years now. I have been trying to figure out what this clip on the Roll Bar Frame assembly is for. I don't see it depicted on any of the numerous drawings I have.

I’m doing the inventory on my finish kit, but can’t identify where these parts are used? 2 plain aluminium machined blocks - AB3-3/4x1 1/2 x 1.188 - seems they should be used for something important with that specific dimension? A spacer for jigging something? Also - a long compression...

Mike picked up his RV-12 this morning with N917PH's new custom paint job by Fulltron. For those RV-12 builders wondering if we paint 12's, the answer is yes, and Fulltron has several more RV-12's scheduled for painting in the near future. Next week we'll have another custom RV-7 paint job...

I’m planning out where to put my remote canopy release handle, and I had initially thought the bottom of the power module would be a good spot. However, it seems my F-14188A Power module front plate is not the same as the one depicted in OP63? (It’s the same as in Section 59). It’s like the...

Pushed out every now and then.