Swingwing
Active Member
I am working on my panel, Dynon, with an ACM board and need help integrating the smoke system.
I am not well-versed in electrical system design so this is my best description of what I think I need to do:
I put an "Arm" switch in the panel to provide 12-volt power to the smoke system. I want to turn the smoke on and off with one of the momentary switches (push on, push off) on a Tosten grip. Is there a relay or control board that I should use? I also need a open/close contact to ground in the relay/board to connect to one of the aux inputs on the ACM so that the display will show if the system is on or off.
I'm open to suggestions. thank you for the help!
I am not well-versed in electrical system design so this is my best description of what I think I need to do:
I put an "Arm" switch in the panel to provide 12-volt power to the smoke system. I want to turn the smoke on and off with one of the momentary switches (push on, push off) on a Tosten grip. Is there a relay or control board that I should use? I also need a open/close contact to ground in the relay/board to connect to one of the aux inputs on the ACM so that the display will show if the system is on or off.
I'm open to suggestions. thank you for the help!