Van's Air Force
Don't miss anything! Register now for full access to the definitive RV support community.
AirMaster Prop
- Thread starter GregMac
- Start date
simpkinsona
Well Known Member
Compatible?
I looked at their website. Looks like they are for lower power applications. The only Lycoming listed is the O-235
I looked at their website. Looks like they are for lower power applications. The only Lycoming listed is the O-235
Isaac
Well Known Member
RE: Airmaster Propeller
Actually, the website list two propellers for the O-320. A three blade 68" diameter and three blade 72" diameter. Not easy to find on their website using their standard product search options. I like the simplicity of how the electric prop control works. Haven't ever seen one or read of one installed on an RV but would be curious about the performance also.
https://www.propellor.com/propeller-systems#/specFilters=1m!#-!118&pageSize=6&orderBy=5&pageNumber=1
Actually, the website list two propellers for the O-320. A three blade 68" diameter and three blade 72" diameter. Not easy to find on their website using their standard product search options. I like the simplicity of how the electric prop control works. Haven't ever seen one or read of one installed on an RV but would be curious about the performance also.
https://www.propellor.com/propeller-systems#/specFilters=1m!#-!118&pageSize=6&orderBy=5&pageNumber=1
ArlingtonRV
Well Known Member
I contacted AirMaster back in Dec 2019 and was told the following:
"We have in development the AP725, expected to be released second half 2020, which is expected to be a match for the engines you are considering. Available prop diameter can be 72-82 inches depending on blade choice. Blades from either Sensenich or Whirlwind can be used. "
"Cost is expected to be USD12920 for a complete system, plus shipping at around USD400-"
"Expected weight and specifications for this system, is shown on the back of the attached brochure."
The brochure is here, I couldn't figure out how to upload a .pdf, so it is a .jpeg.
Also here:https://steverush.smugmug.com/VAF-Posts/i-h8PgRrG/A
and:https://steverush.smugmug.com/VAF-Posts/i-RFvtS5
"We have in development the AP725, expected to be released second half 2020, which is expected to be a match for the engines you are considering. Available prop diameter can be 72-82 inches depending on blade choice. Blades from either Sensenich or Whirlwind can be used. "
"Cost is expected to be USD12920 for a complete system, plus shipping at around USD400-"
"Expected weight and specifications for this system, is shown on the back of the attached brochure."
The brochure is here, I couldn't figure out how to upload a .pdf, so it is a .jpeg.
Also here:https://steverush.smugmug.com/VAF-Posts/i-h8PgRrG/A
and:https://steverush.smugmug.com/VAF-Posts/i-RFvtS5
