What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Stick Wire Routing

bjdecker

Well Known Member
Ambassador
Reference - Section 36, Page 10 - Figure 1.

The 1/4" hole in the CS-00008 for cable routing seems to be in the "wrong" place.

After looking at the stick "in situ", the pivot point, the surrounding structure - it seems like a better place for the stick wiring to exit from the stick is on the same side as the molex connector "flange" in the CS-00007 base.

What am I missing here?
 
Yes i agree.
However, i found the mini Molex connectors not fit for purpose.... :(

They went in the trash. I adopted the Steinair approach using standard d sub pins for the connection, insulating with heat shrink and finished off by
sliding a piece of clear tube to over the top and secured to the stick with clips.
 
They will fit

The Mini Molex will fit but is a little bit of a PITA. (I wired another experimental and used these across the board) Just crimp and wire very carefully and most of the time will be ok, good luck. If you think these are troublesome wait till you wire the elevator trim servo.......
 
Back
Top