What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Mystery part

wirejock

Well Known Member
I recently re-organized the shop. Remaining parts pulled for installation and unused stuff packed with labels.
Anyone know how these are used?
These are some sort of exhaust bracket but I can't find them on a drawing.
20230118_163653.jpg
These are miscellaneous stuff. I think the brass inserts are brake line hardware. The standoffs, clevis pins and washer, I have no idea.
20230118_162639.jpg
 
The stainless steel straps are for the Heater Duct standoffs.

See OP-29, OP-33
 
Yes, the brass inserts are for the brake lines between the pilot and passenger brake master cylinders if you are using dual brakes. They slip into the plastic hose to prevent crushing when the compression nut is tightened. Not needed for single brakes sets.

Roberta
 
The stainless steel straps are for the Heater Duct standoffs.

See OP-29, OP-33

Thanks. I'll take a look.

Yes, the brass inserts are for the brake lines between the pilot and passenger brake master cylinders if you are using dual brakes. They slip into the plastic hose to prevent crushing when the compression nut is tightened. Not needed for single brakes sets.
Roberta

I have Beringer brakes so I'm ok there.
Thanks
 
Clevis pins look similar to the ones on either end of the electric elevator trim pushrod on my 9A.
 
Back
Top