Hi,
Does anyone have exact measurments of SW float type fuel sender arm length and bend length for an RV7A tank? i tried to follow van's instructions of total arm length of about 6", 3" then then bend then another 3" (according to DWG 16A), but the OHMS measurment does not come to the 32 Full -240 empty. Mine is approx 247 empty (basically it bottoms out) and 29 full (top out). I tried bending this arm that holds the float several times, but no success. Also, when had the tank up in the jig, the float rotates (falls) to the side. it will not stay as it should. How are we suppposed to make it stay in place and not rotate?
Does anyone have exact measurments of SW float type fuel sender arm length and bend length for an RV7A tank? i tried to follow van's instructions of total arm length of about 6", 3" then then bend then another 3" (according to DWG 16A), but the OHMS measurment does not come to the 32 Full -240 empty. Mine is approx 247 empty (basically it bottoms out) and 29 full (top out). I tried bending this arm that holds the float several times, but no success. Also, when had the tank up in the jig, the float rotates (falls) to the side. it will not stay as it should. How are we suppposed to make it stay in place and not rotate?