kjelle69
Active Member
I have searched the threads in this forum for information about removal of the vacuum pump. apparently the studs are troublesome to remove. What is the correct procedure? Heat?
Another question is about the oil galley in the engine acessory case. Is it 100% ok to plug it using one of these cover plates?
http://www.aircraftspecialties.aero/cover-vacuum-pump-ael60430/
How will it affect the oil system when it becomes a "dead end" against the plate there?
Another question is about the oil galley in the engine acessory case. Is it 100% ok to plug it using one of these cover plates?
http://www.aircraftspecialties.aero/cover-vacuum-pump-ael60430/
How will it affect the oil system when it becomes a "dead end" against the plate there?