SeanB
Well Known Member
Hello,
I am performing the final tasks on my RV-7 engine cowl. I noticed the below drawing that instructs to cut the scalloped area behind the spinner plate at an angle. Van's Tech Support said this helps provide clearance when installing/removing the bottom cowl. I have never seen a plane with this cut in place.
Has anyone made this cut?
Did it help?
Thanks!
I am performing the final tasks on my RV-7 engine cowl. I noticed the below drawing that instructs to cut the scalloped area behind the spinner plate at an angle. Van's Tech Support said this helps provide clearance when installing/removing the bottom cowl. I have never seen a plane with this cut in place.
Has anyone made this cut?
Did it help?
Thanks!