What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

prop cable

Chipper G

Well Known Member
Trying to figure out what prop control cable length I need. I see some stuff that says reference dwg 21 I don't have that dwg. any help on the length would be appreciated. the engine is a horizontal induction IO360 M1B with the whirlwind prop and gov setup
 
I don't think dwg 21 has the prop cable length on it either, it just specifies where the holes are in the firewall and has a note that says "DETERMINE EXACT LOCATIONS FOR YOUR OWN ENGINE INSTALLATION USING COAT HANGER WIRE TO MEASURE THE FIREWALL TO TERMINATION DISTANCE."

If you register your S/N on the webstore, you should be able to access all the current drawings for your airplane online, rather than having to buy the usb disk. I can send you dwg 21 if you can't access it there.
 
Back
Top