What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Landing light cover gap

hamblin10

Active Member
Has everybody gotten a tight fit of their landing light cover to the leading edge? I seem to keep getting a gap at the apex of about 0.050 inch. Is that acceptable or should I try again? Thanks!
 

Attachments

  • IMG_0913.jpg
    IMG_0913.jpg
    215.2 KB · Views: 123
  • IMG_0914.jpg
    IMG_0914.jpg
    100 KB · Views: 119
Mine is the same. Used a very small amount of clear silicone inside the leading edge (invisible to the eye) to seal the gap.
 
I have a gap too. Spoke to Vans and one suggested using a blow dryer to carefully heat up the lense while installed and push out as your heating it up. Use a clothe to press against the lense. This helped a little.
 
Back
Top