Does anyone know where to get a flat chunk of maybe 2"X24x1/2 with a different radius on each edge?
Nothing fancy. Just a chunk of cold rolled steel with a uniform radius on each edge. 1/16, 1/8, 3/16, 1/4. I can clamp it in place.
I don't use the brake much anymore but one finger for most bends would sure come in handy.
I suppose I could buy a piece and have it milled.
Estes Park, CO
E-mail: wirejock at yahoo dot com
Builder Blog: http://wirejockrv7a.blogspot.com
Donated 12/2022, plus a little extra.
RV-7A #73391, N511RV reserved
I cannot be, nor will I be, held responsible if you try to do the same things I do and it does not work and/or causes you loss, injury, or even death in the process.
Last edited by wirejock : 12-05-2022 at 02:10 PM.