Tail support for my -7A
I'm going to be adding the Super Tracks and to do that I need to move my ELT antenna back about 10" and to do that I need to get in the tail cone and to do that I need a tail stand to keep the tail from crashing to the ground.
So I priced some on AS and they were way more than I wanted to pay. After poking about on the interwebs, I came up with this:
A $35 Harbor Freight grinder stand, some eyebolts, and 3/8" pipe & fittings from Home Depot aviation supply. I didn't even have to drill the grinder stand, just used the existing holes. It would have been a bit simpler if HD had a 8" long nipple but they didn't so I put the coupling on one end and just screw the 6" nipple into that when I hook it to the plane.
Donation paid July 2022