IO-360 Baffle drawings needed

I just discovered that I have been following the instructions to fab/install my cowl baffles using drawing OP-40, which is for O-360's. Can anyone tell me if there is another set of drawings for IO-360's, and if there are, could I get a copy, please?
Thanks.

You may already have the answer from Carl N.

If not, it's on OP-04. I can email you the pdf if you need it...

Me too

Hey Tom,
Would you mind sending me that pdf file too. Thanks.
[email protected] wz(underscore)bang(at)hotmail(dot)com
John Van Lieshout
RV6A 85%
Aerosport IO-375
C-FMYM (reserved)

On its way...

Baffle plans

Thanks for the quick e-mail, Carl. I printed out OP-4, and noticed it was dated 1998. Since then Van's has come out with detailed, step-by-step instructions with drawings (including 2 revisions), but these still only address snorkel-less engine setups.
http://www.vansaircraft.com/pdf/revisions/other/OP-40.pdf

Maybe I'm not missing a complete section of the manual after all; maybe I need to come up with an installation using the short installation pages from my snorkel, Vetterman's exhaust instructions, , the cabin heat muff manufacturer, and my huge intellect?.but I HATE relying on THAT!