kjelle69
Active Member
I am about to install the flywheel and Pacesetter 4" extension after an engine overhaul.
I've been looking through the SSP-1776-5 to see if there are any specific torque for the 1/2 inch extension bolts to the threaded inserts in the chrankshaft flange.
Is it good to go with the standard table for 1/2": 900 to 984 In.Lb. here or is it other specs here because of the dynamics due to rotation?
I've been looking through the SSP-1776-5 to see if there are any specific torque for the 1/2 inch extension bolts to the threaded inserts in the chrankshaft flange.
Is it good to go with the standard table for 1/2": 900 to 984 In.Lb. here or is it other specs here because of the dynamics due to rotation?