I shaped and cut one of the float arms for my fuel level sending unit. I was proud of my crisp bends and exact measurements until I went to install said float arm on the sending unit. It was at that moment that I realized that I missed the part in the plans that shows the small bend at the end.
Does anyone know where you can get a replacement float arm? I contacted Stewart Warner and they gave me the part number, but said I'd have to buy it though a vendor. I contacted Vans and they apparently no longer carry it. I tried punching the part number into google with no luck.
As a last resort, it appears a hinge pin may make a suitable substitute. Does anyone know where I could get one of these float arms?
Does anyone know where you can get a replacement float arm? I contacted Stewart Warner and they gave me the part number, but said I'd have to buy it though a vendor. I contacted Vans and they apparently no longer carry it. I tried punching the part number into google with no luck.
As a last resort, it appears a hinge pin may make a suitable substitute. Does anyone know where I could get one of these float arms?