What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Right Angle BNC connector - how attach center pin

CATPart

Well Known Member
I picked up some BNC right angle connectors for my radio installation. There are no instructions. How do I attach the center conductor? Do I just lay it in that groove and crimp with pliers? Do I solder it?
 

Attachments

  • BNC-1.JPG
    BNC-1.JPG
    126.7 KB · Views: 89
  • BNC-2.JPG
    BNC-2.JPG
    116.6 KB · Views: 74
  • BNC-3.JPG
    BNC-3.JPG
    142 KB · Views: 79
I have always soldered these. Also, I have a coupler that I attach the BNC to, to hold it steady for the soldering process
 
Start by coating your wire with solder, then slip it thru and add heat and a bit more solder.
 
If you have the number on the packaging that the connector came in, you can usually find the manufacturer's instructions on line. Digikey usually has datasheets available if it is one they carry.
 
Back
Top