What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Oil tank bracket question

UNCRV

Active Member
It seems that there was an update to the oil tank bracket between my printer plans and new plans. I have the steel reinforcement and the template but wanted to confirm that I need to cut off the correct portion of the bracket as seen in these pictures. Has anyone done this and can confirm? The instructions with the steel pieces weren’t overly clear but appeared to say cut at the end of the template. The sharpie lines are the end of the template where I think it needs cut. Thanks
 

Attachments

  • 3FDC1298-7F0F-4BB6-9941-66A4F863EB6A.jpg
    3FDC1298-7F0F-4BB6-9941-66A4F863EB6A.jpg
    253.8 KB · Views: 130
  • E3D40884-BC9C-431A-8D44-9043A894C54C.jpg
    E3D40884-BC9C-431A-8D44-9043A894C54C.jpg
    250.5 KB · Views: 108
Back
Top