What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Rear Spar Drill Fixture

Mikeyb

Well Known Member
I put the wings on my plane today. I’m a hazard with a hand drill and would have died of a heart attack if I would have messed up the hole that attaches the rear spar

I made a little drill jig. It’s just a piece of 1X2.75X.5” aluminum bar with a .500” hole bored in the middle to hold removable drill bushings I bought from McMaster.

I clamped them in place when I was setting the incidence. It’s easy to judge the edge distance. As long there is an 1/8” of material above and below the bar you are good.

I stepped the hole size up from #30 to an N drill and bushings then reamed it to 5/16. Nice round hole that is square to the spar fittings.
 

Attachments

  • C16FE645-F5F9-42DB-B478-0971D7A73C97.jpeg
    C16FE645-F5F9-42DB-B478-0971D7A73C97.jpeg
    468 KB · Views: 217
  • 52E007EA-725B-4866-BE79-F8AB259AC798.jpeg
    52E007EA-725B-4866-BE79-F8AB259AC798.jpeg
    461.5 KB · Views: 195
  • B24E9352-D6F0-44FA-9B53-3F3D0BC3CC32.jpeg
    B24E9352-D6F0-44FA-9B53-3F3D0BC3CC32.jpeg
    470.4 KB · Views: 218
  • B0BCF14E-D1D4-4504-B8CD-B327A55666F8.jpeg
    B0BCF14E-D1D4-4504-B8CD-B327A55666F8.jpeg
    512.2 KB · Views: 213
Thanks
Send me a message when you are going to drill yours and maybe I can lend you the brackets and bushings.
Mike
 
That’s simply awesome! Great idea! I am going to either copy this or hit you up in 4 years when I’m at this point!
 
They say great minds think alike...

I did essentially the exact same thing. A nice, round, perpendicular hole with good edge distance. It took all of the "excitement" out of drilling/reaming the rear spar attachment.
 
I put the wings on my plane today. I’m a hazard with a hand drill and would have died of a heart attack if I would have messed up the hole that attaches the rear spar

I made a little drill jig. It’s just a piece of 1X2.75X.5” aluminum bar with a .500” hole bored in the middle to hold removable drill bushings I bought from McMaster.

I clamped them in place when I was setting the incidence. It’s easy to judge the edge distance. As long there is an 1/8” of material above and below the bar you are good.

I stepped the hole size up from #30 to an N drill and bushings then reamed it to 5/16. Nice round hole that is square to the spar fittings.

Looks really nice. I’m sure that bolt in the picture is just a placeholder but make sure that AN5 bolt is installed front to back with the castle nut on the aft side of the spar bar on the final install.
 

Attachments

  • 3E9585E7-0303-48EB-942D-CB2E79DAEC94.jpg
    3E9585E7-0303-48EB-942D-CB2E79DAEC94.jpg
    273.9 KB · Views: 122
Back
Top