View Single Post
  #5  
Old 11-25-2021, 06:52 PM
Draker's Avatar
Draker Draker is offline
 
Join Date: Jun 2016
Location: Livermore, CA
Posts: 656
Default

Quote:
Originally Posted by BobTurner View Post
Above post shows diagram. Yes, shield to proper terminals on both ends, the shield acts as a conductor in this application. You didnít ask, but also note the jumpers installed on the switch - they need to conform to your type mags (as shown, for left impulse, right non-impulse). Also make sure the wires are supported to minimize flexing, especially at the crimps. I once nearly killed myself after a P lead broke right at the connector.
Here's what I think is a pretty nice way to secure the wires on the magneto side. Learned it here on VAF:

__________________
Ryan Drake
Livermore, CA
https://stiletto.smugmug.com/RV7
Donated 12/31/2021
RV-7A (N12VD): Finishing final tasks for airworthiness
Reply With Quote