Question answered - KUDOS to Dynon AGAIN!
Ok, I talked to both David and Don at Dynon today. While, for me at least, the latest Kavlico addendum doesn't make it clear, the EMS D-10 REQUIRES part number 103713-000 (50 psi) for fuel pressure signal. It uses the 150 psi sensor for oil pressure only. Most of the other Dynon EMS systems use the 150 psi sensor for both oil and fuel pressure. The 50 psi sensor comes with it's own resistor that must be installed and requires the selection of 7 on the sensor type entry.
In these days, it is so refreshing to witness superb service, on legacy equipment by any manufacturer. Thanks Don and David!
Last edited by 74-07 : 01-14-2022 at 05:20 AM.