View Single Post
Old 02-05-2020, 06:44 PM
9GT's Avatar
9GT 9GT is offline
Join Date: Jan 2010
Location: Southern Michigan
Posts: 2,250

When I built my RV-10, I did not like the way the Andair valve selector lever could easily rotate out of the indent without having to lift the safety knob, so I filled the pin channel with JB Weld and drilled it out for the pin at the Left/Right/Off positions. That gave me positive position locks in all three positions and the only way to change it was to lift up on the safety knob first. No way it would accidentally move by being bumped . Doing the same on my RV-9A.
David C.
Howell, MI
RV-10: #41686 Under Construction/Sold 2021
RV-9A: #90949 Under Construction
RV-10: #40637 Completed/Sold 2016
Cozy MKIV:#656 Completed/Sold 2007
"Donor Exempt" but donated through Dec. 2021
Reply With Quote