TruTrak Vision 385
Today while taking advantage of the rare nice PNW weather my relatively new TruTrak 385 malfunctioned. "Gyro Set" appeared on the screen for a few seconds, the RV6 started wandering around the sky on its own and I could not shut off the AP without pulling the breaker. The AP disconnect button disconnected the AP for a few seconds but then it reengaged itself with no input from me! This was repeatable so I have to leave the circuit breaker pulled until I figure out what is wrong.
There does not appear to be too much MFG support from Bendix/King for these AP's. I'm not sure what could cause this? It has always worked fine for the last year or so up until now.
RV6A quickbuild, Flying as of 10-14-2017
Mustang II Built and Flying