ronshort2000
Member
I was working on my -10 VS last night and got to a step where I needed to drill a #19 hole and countersink for a #8 bolt. I bought my tool set from Cleveland so I got my #8 CS and the pilot would not fit into the hole. I fiddles with it for a while and looked up the CS on Cleveland's web site. They state "CC8 - #19 drill size for #8 or 8-32 screw - Pilot size 0.166". I measured the pilot on MY CS and it was .197 . Could be a manufacturing error but was curious if anyone else has run into an issue like this. If it was a Mfg error I'd be surprised if I have the only bad one. For all I know it is something I am doing wrong.
I contacted Cleveland and waiting for a response but wanted to ping the group.
I contacted Cleveland and waiting for a response but wanted to ping the group.