[grayforge]

Hi folks,

My Quickbuild kit came with the holes in Bulkhead F-706 and Stiffener F-787 dimpled where the F-788 gusset mates. For some reason, I decided to machine counterrsink the holes in the F-788 gusset for the dimples in the skin. This won't work since there shouldn't be dimpled holes below a machine countersunk sheet of AL.

I talked to Vans support on this one and they thought 2 options were acceptable:

1. Order a new F-788 gusset and dimple it instead of machine countersinking it.
2. Flatten the appropriate dimples in the bulkhead and stiffener.

What do folks think?

Thanks!
Russ

 

[PaulvS]

Flattening the dimples is straightforward and pragmatic.

A third option is to cut your own new F-788 from 2024 sheet and use the existing F-788 to match drill the holes.

 

[grayforge]

Good point on an option 3!