Hi all
I understand the process to use EkoPrime involves scuffing the surface with Ekoetch and maroon scotch brite.
I am going to give this a go on a practice kit in the coming week, and was wondering if anyone could share a high-definition, close-up picture of what a part should look like after that particular step? Just to get a sense about how much scuffing is "just right".
Thanks in advance for your support.
I understand the process to use EkoPrime involves scuffing the surface with Ekoetch and maroon scotch brite.
I am going to give this a go on a practice kit in the coming week, and was wondering if anyone could share a high-definition, close-up picture of what a part should look like after that particular step? Just to get a sense about how much scuffing is "just right".
Thanks in advance for your support.